ASUS Xonar D2X Manual |
Before proceeding with the following steps of installation, disable the audio device integrated into the BIOS Setup or uninstall any other your PC sound card is recommended. (For the configuration of the BIOS or the uninstallation of other sound cards, refer to the user manuals for your card mother and sound card). Turn off your computer and disconnect the power cord. Open the computer case. Remove the metal supports a PCI Express slot x 1 not used for the audio card and its adjacent MIDI card slot (you can remove one if you don't need to use MIDI card in the Pack).
Opposite stand the sound card Xonar D2X to the rear panel of your computer and gently insert the sound card into an available PCI Express slot. Make sure that it is fully inserted into the PCI Express slot. Make sure that golden card PCI Express connector pins are aligned with the PCI Express connector base before inserting the card into the PCI Express Si slot is not adjusted correctly, remove gently and try again). Attach the audio card bracket to the back of your computer with the screw you removed. See section 3.1. Connect the power cord from its power supply to the power connector on the Xonar D2X audio card. High-quality PCI Express sound card requires additional power from your computer. If the power cable is not correctly connected, the audio card will not work at all. When you remove the power cord from the Xonar D2X audio card, be sure to first remove the 4-pin plug and then unplug it from the power connector as shown in the following images. Do not remove with force the head of the power connector; Doing so can remove the power connector on the audio card and cause damage.
Set the MIDI support to another slot in the back of the computer housing. 2. connect MIDI connector 4-pin audio card with MIDI cable MIDI support as shown below. If you want to use the physical reproduction of your CD-ROM drive buttons to control playback of CD audio on your PC, you must connect the analog cable between the CD-ROM drive and sound card. Otherwise, you can skip this section and use the normal digital CD playback in Windows. 2. connect the 4 pins CD-in connector to the analog output on the back of your CD drive / DVD-ROM with the cable from audio CD that normally comes with the CD drive / DVD-ROM drive.
0 Response to "ASUS Xonar D2X Manual"
Post a Comment